LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit Connect XL, Van Cargo >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - 2.5L DURATEC (125KW/170PS) >> Removal And Installation >> Thermostat >> Removal

Removal And Installation: Thermostat: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
  2. NOTE: Cover the accessory drive belts to prevent coolant contamination of the belts.

    Completely cover the accessory drive belts with waterproof plastic.

  3. NOTE: Be prepared to collect escaping fluid.

    • Release the clamp and disconnect the lower radiator hose. Use the General Equipment: Hose Clamp Remover/Installer

    • Release the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer

    GFD304428Courtesy of FORD MOTOR COMPANY
    • Remove the bolts and the thermostat housing.

      Torque: 89 lb.in (10 Nm)

    • Remove and discard the thermostat housing gasket.

GFD304429Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals