LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit Connect XL, Van Cargo >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lighting >> General Procedures >> Front Fog Lamp Adjustment (Procedure 2)

Front Fog Lamp Adjustment (Procedure 2)

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Activation 

  1. NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.

    1. Before starting the fog lamp assembly adjustment:

    • Check the tire inflation.

    • Make sure there are no other loads in the vehicle other than a half tank of fuel.

    • Make sure the vehicle is on level ground.

    • Make sure the fog lamps and headlamps are clean.

    • Make sure the headlamps are operating and are correctly aimed.

  2. NOTE: The vertical wall screen must be a minimum of 2.4 m (7.87 ft)

    Park the vehicle on a level surface approximately 7.6 m (24.93 ft) from the vertical wall or screen directly in front of it.

    GFD305752Courtesy of FORD MOTOR COMPANY
  3. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 101.6 mm (4 in) below the horizontal center of the fog lamps.

    1. Top edge of high intensity zone.
    2. Height of fog lamp centers.
    3. Car axis.
    4. 10 cm (4in)

GFD305753Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals