Pinpoint Test P : U0300: 57, U3000: 44, U3000: 45, U3000: 46, U3000: 49
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PAM U0300: 57 Internal Control Module Software Incompatibility: Invalid/Incompatible Software Component This DTC sets in the PAM due to internal software issue. PAM U3000: 44 Control Module: Data Memory Failure This DTC sets in the PAM when module memory fails. PAM U3000: 45 Control Module: Program Memory Failure This DTC sets in the PAM when module memory fails. PAM U3000: 46 Control Module: Calibration/Parameter Memory Failure This DTC sets in the PAM when module memory fails. PAM U3000: 49 Control Module: Internal Electronic Failure This DTC sets in the PAM sets due to an internal module issue. Possible Sources
- PAM
- P1 CARRY OUT THE PAM (PARKING ASSIST CONTROL MODULE) SELF TEST
- Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).
- CARRY OUT the PAM self-test.
Did the DTC return?
Yes INSTALL a new PAM REFER to: Parking Assist Control Module (PAM) . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.