LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Taurus SE, Gas/Ethanol >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes (Diagnosis & Testing - Removal & Installation) >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Installation

Instrument Panel Cluster (IPC): Installation

  1. Position the IPC in the instrument panel, connect the electrical connector and install the 4 screws.
  2. Install the IPC finish panel. For additional information, refer to Instrument Panel and Console .
  3. If installing a new IPC, download the IPC configuration information from the scan tool into the new IPC. For additional information, refer to Programmable Module Installation(PMI) in Module Configuration .
  4. NOTE: If installing a new IPC on vehicles that are not equipped with IA, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM may result in a no start condition.

    If installing a new IPC on vehicles that are not equipped with IA, carry out the parameter reset procedure. For additional information, Refer to the appropriate Electronic Feature article for the procedure.

  5. NOTE: If equipped, the vehicle's Integrated Keyhead Transmitter(IKT) keys must be programmed to the new IPC.

    If installing a new IPC, carry out the PATS key programming. For additional information, Refer to the appropriate Electronic Feature article for the procedure.

scientia non olet · About LEMON Manuals