Pinpoint Test A : The Adjustable Pedals Only Move In 1-Second Intervals
- A1 RETRIEVE THE SCCM DTCs
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Self Test -- SCCM.
Were DTC B1368:11 or B1386:12 retrieved?
Yes GO to A2. No If no DTCs were retrieved, CONFIGURE the SCCM using As-Built data. If other SCCM DTCs were retrieved, REFER to DTC Chart . - A2 CHECK THE SCCM HALL-EFFECT CIRCUITS FOR A SHORT TO VOLTAGE
- Ignition OFF.
- Disconnect: Adjustable Pedal Motor C2159.
- Disconnect: SCCM C2414A.
- Ignition ON.
- Measure the voltage
between:
Positive Lead Negative Lead Pin Circuit Pin Circuit C2414A-22 RPP06 (GN) -- Ground C2414A-26 LPP06 (YE/BU) -- Ground
Is any voltage present?
Yes REPAIR the affected circuit(s). No GO to A3. - A3 CHECK THE SCCM HALL-EFFECT CIRCUITS FOR A SHORT TO GROUND
- Ignition OFF.
- Measure the resistance
between:
Positive Lead Negative Lead Pin Circuit Pin Circuit C2414A-22 RPP06 (GN) -- Ground C2414A-26 LPP06 (YE/BU) -- Ground
Are the resistances greater than 10, 000 ohms?
Yes GO to A4. No REPAIR the affected circuit(s). - A4 CHECK THE SCCM HALL-EFFECT CIRCUITS FOR AN OPEN
- Measure the resistance
between:
Positive Lead Negative Lead Pin Circuit Pin Circuit C2414A-22 RPP06 (GN) C2159-3 RPP06 (GN) C2414A-26 LPP06 (YE/BU) C2159-4 LPP06 (YE/BU)
Are the resistances less than 3 ohms?
Yes GO to A5. No REPAIR the affected circuit(s). - Measure the resistance
between:
- A5 CHECK THE SCCM HALL-EFFECT CIRCUITS FOR A SHORT TOGETHER
- Measure the resistance
between:
Positive Lead Negative Lead Pin Circuit Pin Circuit C2414A-22 RPP06 (GN) C2414A-26 LPP06 (YE/BU)
Is the resistance greater than 10, 000 ohms?
Yes INSTALL a new brake pedal and bracket. REFER to Brake Pedal and Bracket . CLEAR the DTCs. REPEAT the self-test. If DTC B1368:11 or B1368:12 is retrieved again, INSTALL a new SCCM. REFER to Steering Column Switches . No REPAIR the affected circuit(s). - Measure the resistance
between: