Pinpoint Test D : Clutch Pedal Switch "B" Circuit P0833: Notes
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Jump (push) starting the engine will cause an engine RPM correlation error when the engine rotates without a starter motor crank command. Incorrectly installed or aftermarket alarm systems may also induce this fault.
Refer to CRUISE CONTROL for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Cruise Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| PCM P0833:00 | Clutch Pedal Switch "B" Circuit: No Sub Type Information | A DTC that sets when the PCM receives the vehicle speed input, indicating movement and does not detect the switching input signal from the CPP speed control deactivator switch. This condition disables cruise control. |
Possible Sources
-