Brake Pedal and Bracket: Installation

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch. Install this switch with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing this switch with the pedal in any other position results in incorrect adjustment and damages the switch.

To install, reverse the removal procedure.
NOTE: Make sure that the brake booster pushrod is correctly located.

Install the brake booster and tighten the nuts in sequence.

Torque: 18 lb.ft (25 Nm)

Courtesy of FORD MOTOR COMPANY