Brake Master Cylinder: Installation

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.

To install, reverse the removal procedure.

Material: Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)
- If a new brake master cylinder has been installed, bleed the brake master cylinder. Refer to: Component Bleeding .
- If the brake master cylinder was removed to access other components, bleed the brake system. Refer to: Brake System Pressure Bleeding .