LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Taurus Limited, FWD, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Abs Guided Routine Testing) >> Pinpoint Tests >> Pinpoint Tests BL: SASM Ignition Input Circuit Fault >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2018 Lincoln MKZ, 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, and 2018 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

The SASM requires an operating voltage between 8 and 17 volts. The SASM receives fused ignition voltage from the BCM run-start bus. The SASM sets this DTC if there is excessive resistance or an open in this circuit, including an open fuse. 

PPT BL SASM DTC FAULT TRIGGER CONDITION TABLE

DTC Description Fault Trigger Conditions
U3011:13 Ignition Input Off: Circuit Open This DTC sets if the ignition voltage supplied to the SASM is below 6 volts for more than one second.
scientia non olet · About LEMON Manuals