DTC U3000: Control Module
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2019 Ford Expedition, 2018 Lincoln MKZ, 2018 Ford Transit-350 HD, 2018 Ford Transit-350, and 2018 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.
| Failure | Action |
|---|---|
| 41 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 42 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 46 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 54 | Using a diagnostic scan tool, CARRY OUT the OCS Reset. FOLLOW all instructions on the diagnostic scan tool. If the OCS Reset was not successful, VERIFY correct installation of the OCS. VERIFY the pressure sensor hose is correctly routed and CORRECT the installation as necessary. REPEAT the self-test. If DTC U3000:54 is still present, INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |