LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Taurus Limited, FWD, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Automatic Transmission - 6-Speed Automatic Transmission - 6F15 (2 Of 2)) >> Disassembly And Assembly Of Subassemblies >> Transmission Case >> Disassembly

Transmission Case: Disassembly

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Press the bushing out of the transmission case from the outside to the inside so the transmission case rests on a flat surface.

    Using the special tools, remove and discard the LH transmission case bushing from the transmission case. Use Special Service Tool: 206-084 Installer, Wheel Speed Sensor Ring. Use the General Equipment: Hydraulic Press

    GFD327178Courtesy of FORD MOTOR COMPANY
  2. Remove the differential ring gear snap ring. Use the General Equipment: Flat Headed Screw Driver
    GFD327179Courtesy of FORD MOTOR COMPANY
  3. Remove the differential ring gear.
GFD327180Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals