LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Taurus Limited, FWD, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (RCM Guided Routine Testing -- (Pinpoint Tests K - ZB)) >> Pinpoint Tests >> Pinpoint Tests PD: Event Notification Signal (RCM to PCM) - Fiesta >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2019 Ford Expedition, 2018 Lincoln MKZ, 2018 Ford Transit-350 HD, 2018 Ford Transit-350, and 2018 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.

On vehicles equipped with a gas engine, the RCM transmits an event notification signal which communicates fuel cut-off status and SRS deployment status to the PCM. This allows the PCM to initiate fuel cut-off in the event of a crash. 

The RCM monitors the event notification signal circuit for the following faults:

If a fault is detected, the RCM stores DTC B11D8:12 or B11D8:14 in memory. The airbag warning indicator does not illuminate if B11D8:12 or B11D8:14 is set.

PPT P RCM DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
B11D8:12 Restraint Event Notification: Circuit Short to Battery Sets when the RCM senses a short to voltage from the event notification signal circuit for more than 15 seconds.
B11D8:14 Restraint Event Notification: Circuit Short to Ground or Open Sets when the RCM senses a short to ground or an open from the event notification signal circuit for more than 15 seconds.