Outer Constant Velocity (CV) Joint Boot: Installation

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Grease sachet is supplied with boot kit.

Install the outer CV boot and apply grease to the inside of CV boot.

Material: Grease (WSS-M1C272-A)

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that new components are installed.

NOTE: Do not move the CV joint housing. Make sure that the CV joint boot is installed with the boot in the CV groove.
- Using the special tool, position back the CV boot and install the new large halfshaft boot clamp. Use Special Service Tool: 204-169 Clamping Tool, Boot Retaining Clamp.
Courtesy of FORD MOTOR COMPANY
Install the inner CV joint boot. Refer to: Inner Constant Velocity (CV) Joint Boot .