Front Suspension - Overview
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
The front suspension consists of the following components:
- Lower arms
- Stabilizer bar, bushings and links
- Wheel bearings
- Wheel hubs
- Wheel knuckles
- Wheel studs
- Suspensions strut and spring assemblies
The front suspension uses a MacPherson strut system. This suspension system incorporates a strut assembly that takes the place of the upper arm and ball joint. The strut performs the function of a shock absorber and is encompassed by a coil spring. The strut and spring assembly carries the sprung weight of the vehicle and is also the pivot point for the steering knuckle. This system uses a lower control arm and ball joint for the lower (unloaded) pivot point of the steering knuckle.
NOTE:
The ABS sensor toothed ring is integrated into the wheel hub. Incorrect installation of the wheel hub will cause a malfunction of the ABS.
NOTE:
The ball joint on the suspension arm cannot be renewed separately in service. In service, the complete suspension arm must be changed.