Tie Rod End: Removal

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel and tire. Refer to: Wheel and Tire .
NOTE: Make sure that a new nut is installed.

Remove and discard the tie rod end nut.

Torque: 39 lb.ft (53 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that the ball joint ball does not rotate.

Loosen the tie rod end jamb nut.

Torque: 46 lb.ft (63 Nm)

Courtesy of FORD MOTOR COMPANY
Separate the tie rod end from the wheel knuckle. Use Special Service Tool: 211-001 (TOOL-3290-D) Remover, Tie-Rod End.

Courtesy of FORD MOTOR COMPANY
NOTE: Note the position of the component before removal.

NOTE: Make sure that the tie rod end is installed with the same number of turns as when removed.

Remove the tie rod end.

Courtesy of FORD MOTOR COMPANY