LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Taurus Limited, FWD, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Electronic Engine Controls - 1.0L ECOBOOST (92KW/125PS)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Programming .

  3. NOTE: This step is only necessary when installing a new component.

    Reprogram the Passive Anti-Theft System (PATS) Refer to: Anti-Theft Key Programming - Scan Tool . Refer to: Key Programming Using Two Programmed Keys .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

  5. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the transmission strategy download procedure, following the on-screen instructions. Refer to: TRANSMISSION STRATEGY DOWNLOAD .

scientia non olet · About LEMON Manuals