Pinpoint Test R : U2024: 41, U2100: 00, U2101: 00
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PAM U2024: 41 Control Module Cal-Config Data: General Checksum Failure This DTC sets due to incomplete or incorrect PMI procedures. PAM U2100: 00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. PAM U2101: 00 Control Module Configuration Incompatible: No Sub Type Information This DTC sets due to incomplete or incorrect PMI procedures. Possible Sources
- PAM
- R1 CARRY OUT PMI (PROGRAMMABLE MODULE INSTALLATION)
- CHECK vehicle history for recent service actions related to the PAM.
Were there any recent service actions with the PAM?
Yes REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. No INSTALL a new PAM. Use As-Built data when carrying out PMI. REFER to: Parking Assist Control Module (PAM) .