DTC Chart: Occupant Classification System Module (OCSM)
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
OCSM DTC Chart
| DTC | Description | Action |
|---|---|---|
| B00C0:11 | Passenger Seat Occupant Classification Sensor "A": Circuit Short to Ground | INSPECT the OCS for any damage and for correct installation. If damage is found, REPAIR the root cause of the damage and INSTALL a new OCS, as necessary. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . If any installation concerns are found, CORRECT the OCS installation, referring to the OCS Removal and Installation procedure as needed to make sure the sensor hose is correctly routed. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . If no damage or installation concerns are found, INSTALL a new OCS. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| B00C0:12 | Passenger Seat Occupant Classification Sensor "A": Circuit Short to Battery | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| B00C0:16 | Passenger Seat Occupant Classification Sensor "A": Circuit Voltage Below Threshold | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| B00C0:49 | Passenger Seat Occupant Classification Sensor "A": Internal Electronic Failure | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| B00C0:7B | Passenger Seat Occupant Classification Sensor "A": Low Fluid Level | INSPECT the OCS for any damage and for correct installation. If damage is found, REPAIR the root cause of the damage and INSTALL a new OCS, as necessary. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . If any installation concerns are found, CORRECT the OCS installation, referring to the OCS Removal and Installation procedure as needed to make sure the sensor hose is correctly routed. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . If no damage or installation concerns are found, INSTALL a new OCS. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| B1193:00 | Crash Event Storage Full and Locked: No Sub Type Information | CLEAR the OCSM Diagnostic Trouble Codes (DTCs). CYCLE the ignition from ON to OFF and back to ON. REPEAT the OCSM self-test. If DTC B1193:00 returns, INSTALL a new OCS sensor. INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| U0100:00 | Lost Communication with ECM/PCM A: No Sub Type Information | REFER to: Pinpoint Test - DTC: U . |
| U0151:00 | Lost Communication with Restraints Control Module: No Sub Type Information | REFER to: Pinpoint Test - DTC: AP Vehicles With: Rear Seat Side Airbag . |
| U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | CARRY OUT the PCM self-test. REFER to the appropriate service information. Refer to the appropriate Engine Information for the procedure. |
| U3000:41 | Control Module: General Checksum Failure | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| U3000:42 | Control Module: General Memory Failure | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| U3000:46 | Control Module: Calibration / Parameter Memory Failure | INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| U3000:54 | Control Module: Missing Calibration | Using a diagnostic scan tool, CARRY OUT the OCS Reset. FOLLOW all instructions on the diagnostic scan tool. If the OCS Reset was not successful, VERIFY correct installation of the OCS. VERIFY the pressure sensor hose is correctly routed and CORRECT the installation as necessary. REPEAT the self-test. If DTC U3000:54 is still present, INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Rear Seat Side Airbag . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | REFER to: Pinpoint Test - DTC: AM Vehicles With: Rear Seat Side Airbag . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | REFER to: Pinpoint Test - DTC: AM Vehicles With: Rear Seat Side Airbag . |