GFM DTC Chart
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B1D19:49 | Compact Disc Unit: Internal Electronic Failure | DIAGNOSE all other GFM Diagnostic Trouble Codes (DTCs) first. If no other Diagnostic Trouble Codes (DTCs) are present, INSTALL a new GFM (CD player). |
| B1D19:4B | Compact Disc Unit: Over Temperature | ALLOW the vehicle interior to reach ambient temperature. REPEAT the GFM self-test. If the DTC is retrieved again, INSTALL a new GFM (CD player). If the DTC is not retrieved again, the system is operating correctly. The concern was caused by an temporary overheating condition. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test Y |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test AB |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | INSTALL a new GFM (CD player). |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | INSTALL a new GFM (CD player). |
| U3000:41 | Control Module: General Checksum Failure | INSTALL a new GFM (CD player). |
| U3000:42 | Control Module: General Memory Failure | INSTALL a new GFM (CD player). |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AG |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AH |