Network Message Chart
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
Module Network Input Messages - ABS Module
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Brake on-off switch | PCM | This message informs the ABS module the driver has pressed the brake pedal. This message is also used by the ABS module to check the brake pressure sensor located inside the HCU. |
| Clutch pedal switch | IPC (manual transmission only) | This message informs the ABS module the driver has pressed the clutch pedal. |
| Engine speed | PCM | This message informs the ABS module of the current engine speed in RPM. |
| Engine status | PCM | This message informs the ABS module of the current status of the engine; off, ready, cranking, running, stalled, after-run, or shutdown. |
| Ignition status | IPC | This message informs the ABS module of the current ignition status; off, accessory, run, start, unknown or invalid. |
| Parking brake status | IPC | This message informs the ABS module of the current parking brake status: applied or released. |
| Power mode | IPC | This message provides the ABS module with the current ignition status; key out, key recently out, key approved, post accessory, accessory, post ignition, ignition ON, engine running, engine running standby, engine running starting in progress and engine cranking. |
| Selector lever (PRNDL) status | PCM | This message informs the ABS module of the current driver selected gear. |
| Vehicle configuration data | IPC | This message provides the ABS module with the current optional and configured items such as, tire size, axle ratio, manual or automatic transaxle, keyless entry, and VIN. |