DTC C200B: Steering Shaft Torque Sensor 1: Description
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
The PSCM continually monitors the steering shaft torque sensor when the ignition is ON and the voltage supply to the PSCM is above 10 volts.
- DTC C200B:2F (Steering Shaft Torque Sensor 1: Signal Erratic) - If the steering shaft torque sensor signal is outside the expected range, DTC C200B:2F is set.
- DTC C200B:61 (Steering Shaft Torque Sensor 1: Signal Calculation Failure) - If the steering shaft torque sensor signal is not within a certain threshold, DTC C200B:61 is set.
- DTC C200B:62 (Steering Shaft Torque Sensor 1: Signal Compare Failure) - If a malfunction is detected in the steering shaft torque sensor, DTC C200B:62 is set.