Seat Cushion Thermo-Electric Device: Installation

All seats 

1. Position the cushion TED to the seat.
2. Attach the cushion TED.
   1. Engage the front retainers.
   2. Engage the rear retainers.
   3. Connect the electrical connector.

3. NOTE: To identify the Occupant Classification System(OCS) system, refer to Seat -- Exploded View, Front  in this information.

   Install the seat.

   If a passenger seat with an OCS bladder system has been serviced, do not prove out the Supplemental Restraint System(SRS) within the seat installation procedure. Proceed to the next step here after the seat has been installed in the vehicle and repower has been done.  For additional information, refer to procedures in this information.

   Passenger seat with an Occupant Classification System(OCS) bladder system 

4. Carry out the Occupant Classification System(OCS) System Reset. For additional information, refer to the GENERAL PROCEDURES .