Seat Backrest Cover - Rear, 40 Percent: Installation
- If required, install backrest foam pad to he backrest frame.
- Position the backrest cover to the backrest foam pad. Attach the wires to the clips and the hook-and-loop strips.
- Route the heated seat mat wire harness and connector through the backrest cover (if equipped).
- Route the latch release strap through the backrest cover.
- Attach the backrest cover hook-and-loop strips and engage the retainers on each side.
- Engage the backrest cover J-clips and hook-and-loop strips at the bottom.
- Attach the heater mat electrical connector (if equipped).
- Install the pivot grommet.
- Install the 2 head restraint guide sleeves. For additional information, refer to Head Restraint Guide Sleeve -- Front in this information.
- Install the rear seat backrest. For additional information, refer to Seat Backrest -- Rear in this information.