Seat Cushion Cover - Front: Installation

All seats 

1. If required, install cushion foam pad on the cushion frame.
2. Position the cushion cover and engage the wires into the retainers of the cushion foam pad.
   • If equipped with heated seats, make sure the cushion heater mat windows are trapped between the cushion cover wire and cushion foam pad retainers.

3. Engage the cushion cover retainers to the cushion frame and seat track.
   • Do not engage the outboard cushion cover retainers, if equipped with manual lumbar.

4. NOTE: To identify the Occupant Classification System(OCS) system, refer to Seat -- Exploded View, Front  in this information.

   Install the front seat backrest.

   If a passenger seat with a bladder OCS has been serviced, do not prove out the SRS within the seat installation procedure. Proceed to the next step here after the seat has been installed in the vehicle and repower has been done.  For additional information, refer to procedures in this information.

   Passenger seat with a bladder OCS 

5. Carry out the Occupant Classification System(OCS) System Reset. For additional information, refer to the GENERAL PROCEDURES .