Seat Backrest Thermo-Electric Device: Installation

Install the backrest TED.
1. Position the TED through the power lumbar cable.
2. Attach the TED to the backrest foam pad wire.
3. Engage the TED upper retainers to the backrest frame wire.
4. Connect the electrical connector and attach the pin-type retainer.
Roll the backrest cover down, attach the hook-and-loop strips and engage the J-clip at the rear to the backrest frame wire.
Roll the backrest cover down, attach the hook-and-loop strips and install the 3 second row hog rings.
Roll the backrest cover down, attach the hook-and-loop strips and install the 3 first row hog rings.
Roll the backrest cover down and attach the hook-and-loop strips.
Route the wire harness(es) and air hoses (if equipped) through the hole(s) in the backrest cover and engage the lower J-clips.
On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.
Install the seat backrest. For additional information, refer to Seat Backrest -- Front in this information.