Lumbar Assembly - Power: Removal

NOTE: For parts identification and location, refer to Seat -- Exploded View, Front in this information.

Remove the seat backrest. For additional information, refer to Seat Backrest -- Front in this information.
NOTE: Note wire harness routing for installation.

Disengage the backrest cover lower J-clips and route the wire harness(es) out of the hole(s) in the backrest cover.

Courtesy of FORD MOTOR COMPANY
On each side, separate the backrest cover clip and hook-and-loop strips.

Courtesy of FORD MOTOR COMPANY
NOTE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest cover up to the first row of hog rings.
If equipped, disconnect the backrest Thermo-Electric Device(TED) electrical connector and disengage the pin-type retainer.

Courtesy of FORD MOTOR COMPANY
Remove the power lumbar.
- Disconnect the motor and disengage the retaining clips.

Courtesy of FORD MOTOR COMPANY