Lumbar Assembly - Manual: Removal
NOTE:
For parts identification and location, refer to Seat -- Exploded View, Front in this information.
- Remove the backrest. For additional information, refer to Seat Backrest -- Front in this information.
-
NOTE: Note wire harness routing for installation.
Disengage the backrest cover lower J-clips and route the wire harness out of the hole in the backrest cover.
- On each side, separate the backrest cover clip and hook-and-loop strips.
-
NOTE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.
Separate the hook-and-loop strips and invert the backrest cover up to the first backrest cover wire.
- Remove the manual lumbar.
- Disengage the cable.
- Disengage the manual lumbar retainers.
-
NOTE: Do not let metal shavings get into the seat track. Failure to follow this instruction can result in seat track damage and failure.
Remove the rivets and the manual lumbar control.