Lumbar Assembly - Manual: Installation
- Position the manual lumbar control and install new rivets.
- Engage the manual lumbar retaining clips and cable retainer.
- Roll the backrest cover down and attach the hook-and-loop strips.
- Route the wire harness through the hole in the backrest cover and engage the lower J-clips.
- Make sure the manual lumbar cable is routed out from the outboard side of the backrest cover before engaging the lower J-clips.
- On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.
- Install the seat backrest. For additional information, refer to Seat Backrest -- Front in this information.