Seat Backrest - Rear, 60 Percent: Disassembly
| Item | Part Number | Description |
|---|---|---|
| 1 | N605892 | Armrest bracket-to-backrest frame bolts (2 required) |
| 2 | W790164 | Washer (2 required) |
| 3 | W505263 | Latch-to-backrest frame bolts (2 required) |
| 4 | 624A94 | Latch release cable |
| 5 | 61383 | Backrest latch |
| 6 | 613A38 | 60 percent backrest frame |
| 7 | 610A16 | LH head restraint guide sleeve |
| 8 | 610A18 | RH head restraint guide sleeve |
| 9 | 611A08 | Center head restraint |
| 10 | 611A09 | Outboard head restraint |
| 11 | 501A04 | Center head restraint cover |
| 12 | 501A04 | Outboard head restraint cover |
| 13 | 66800 | Backrest foam pad |
| 14 | 67203 | LH armrest cover |
| 15 | 67112 | Armrest |
| 16 | -- | Screws (2 required) |
| 17 | 67202 | RH armrest cover |
| 18 | 14D696 | Backrest heater mat |
| 19 | -- | Pin-type retainers |
| 20 | 66600 | Backrest cover |
- Remove the rear seat backrest. For additional information, refer to Seat Backrest -- Rear in this information.
- Remove the 4 head restraint guide sleeves. For additional information, refer to Head Restraint Guide Sleeve -- Front in this information.
- If equipped, separate the heater mat electrical connector.
- Disengage the backrest cover J-clip at the bottom, separate the hook-and-loop strips and disengage the retainers on each side.
- Remove the 2 bolts and armrest with bracket.
- Remove the 2 pin-type retainers at the armrest pocket.
- Remove the backrest frame from the foam pad.
-
NOTE: Use care when separating the backrest cover wires from the backrest foam pad clips, or the clips can be torn from the backrest foam pad.NOTE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the backrest foam pad.
Release the hook-and-loop strips, disengage the wires from the clips and remove the backrest cover.
- Route the heated seat mat wire harness and connector out of the backrest cover (if equipped).
- Disengage the 2 cable retainers, remove the 2 bolts and latch.
- Remove the screw at each armrest side cover, slide up and remove.