Turn Signal and Hazard Lamps: Overview

The turn lamp system consists of:

• Front turn lamps
• Rear lamp assemblies
• Multifunction switch
• SCCM
• FCIM
• BCM

When the multifunction switch is placed in the left or right TURN position, the corresponding turn lamps flash on and off.

The hazard flasher switch is located in the center instrument panel finish panel (integrated into the FCIM). When the hazard function is active, all the turn lamps flash on and off.

The front turn signal indicator lamps are integrated into the headlamp assemblies.

The rear turn signal indicator lamps operate independently of the stoplamps. (Taurus only)

The rear turn signal indicator lamps and the stoplamps share the same bulb. (Police only)