Pinpoint Test E : The Rear Video Is Inoperative - With 4.2 In (106.68 Mm) Display: Notes
Diagnostic Overview
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.
Refer to Parking Aid, Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to Image Display in Parking Aid .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B115E:08 | Camera Module: Bus Signal/Message Failure | An on-demand DTC that sets in the BCM if there is a LIN communication fault from the video camera. |
FCDIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous and on-demand DTC that sets in the FCDIM if no video signal is detected from the video camera when the vehicle is in reverse. |
Possible Sources
- Fuse
- Wiring, terminals or connectors
- Video camera
- Reverse lamp input
- FCDIM concern