Pinpoint Test C : Visual Park Aid Is Inoperative
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- C1 VERIFY THE VISUAL PARK AID IS ENABLED
- Verify that the visual park aid is enabled in the FDIM.
Is the visual park aid enabled in the FDIM '
Yes GO to C2. No Enable the visual park aid. - C2 CHECK THE DTCs FROM THE PAM SELF-TEST
- Using a scan tool, perform the PAM self-test.
Are any PAM DTCs recorded?
Yes REPAIR all PAM DTCs first. REFER to Parking Aid . No GO to C3. - C3 CHECK THE DTCs FROM THE BCM SELF-TEST
- Using a scan tool, perform the BCM self-test.
Are any BCM DTCs recorded?
Yes REFER to DTC Charts in this information. No GO to C4. - C4 CHECK FOR CORRECT VIDEO CAMERA OPERATION
- Disconnect the video camera connector.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the video camera connector. Make sure it seats and latches correctly.
- Operate the system and verify the concern is still present.
Is the concern still present?
Yes INSTALL a new video camera. REFER to Video Camera . No The system is operating correctly at this time. The concern may have been caused by the video camera connection. ADDRESS the root cause of any connector or pin issues.