Gearshift Lever Boot: Removal
WARNING: This page is about a different variant/trim than selected.
-
- Apply 2" wide painters delicate surface tape 360 degrees around the gearshift knob surface.
- Using a 8" rubber strap wrench, rotate the gearshift knob counterclockwise and remove the gearshift knob. Use the General Equipment: Strap Wrench
- Using an interior trim remover, release the gearshift lever boot from the floor console starting at the front sides and moving rearward. Use the General Equipment: Interior Trim Remover
- Release the retainers and remove the gearshift lever boot.