LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Engine Controls - 5.2L 32V Ti-VCT) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal

Crankshaft Position (CKP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: The CKP sensor and crankshaft rear seal retainer plate must be removed and discarded together. The CKP sensor must be installed as part of the crankshaft rear seal with retainer plate kit.
  1. Remove the CKP sensor. Refer to: Crankshaft Rear Seal with Retainer Plate .
scientia non olet · About LEMON Manuals