Pinpoint Test A : Engine Does Not Crank: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | The PCM sets this DTC when no engine rotation is detected during a crank event. |
| P0830 | Clutch Pedal "A" Circuit | The PCM sets this DTC when the PCM receives vehicle speed input, indicating vehicle movement and does not detect the switching input from the clutch pedal position switch. |
| P0830:11 | Clutch Pedal Switch "A" Circuit: Circuit Short To Ground | The BCM sets this DTC when a short to ground is detected on the clutch bottom of travel circuit during an on-demand self test. |
Possible Sources
- Battery
- Battery cables
- IPC
- Starter motor
- BJB starter relay
Visual Inspection and Diagnostic Pre-checks
- Inspect the run/start relay.
- Inspect the high current BJB connections.
- Verify the BJB fuse 60 (5A).
- Verify the BJB fuse 30 (30A).
- Inspect the passive key.
- Inspect the CPP switch (manual transmission only).