Turbocharger Oil Supply Tube: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Do not reuse the turbocharger oil filter, a NEW turbocharger oil filter must be installed.

Install the NEW turbocharger oil filter.

Courtesy of FORD MOTOR COMPANY
Lubricate the O-ring seal with clean engine oil. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: The oil supply tube must be fully seated prior to fastener rundown.

NOTE: Install the NEW TC oil supply tube assembly and the TC oil supply tube retaining bolts finger tight at this stage.
1. Tighten the TC oil supply tube retaining bolt.
  Torque: 89 lb.in (10 Nm)
2. Tighten the TC oil supply tube retaining bolt.
  Torque: 18 lb.ft (25 Nm)
Courtesy of FORD MOTOR COMPANY
Install the turbocharger outlet pipe and then tighten the turbocharger outlet pipe clamps.
Torque: 44 lb.in (5.0 Nm)

Courtesy of FORD MOTOR COMPANY
Connect the turbocharger bypass valve electrical connector. Attach the wire harness retainers.

Courtesy of FORD MOTOR COMPANY
Install the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
Check and top off the engine oil as necessary. Refer to: Specifications .