LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Ignition - 5.2L 32V Ti-VCT) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal

Ignition Coil-On-Plug: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the PCV quick release couplings and position the PCV hoses out of the way. Refer to: Quick Release Coupling .
    GFD287147Courtesy of FORD MOTOR COMPANY
  2. Remove the ignition coil-on-plug covers.
    GFD287148Courtesy of FORD MOTOR COMPANY
  3. Disconnect the ignition coil-on-plug electrical connectors.
    GFD287149Courtesy of FORD MOTOR COMPANY
  4. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.
    NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

    1. Remove the ignition coil-on-plug bolts.
    2. Remove the ignition coil-on-plugs.

GFD287150Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals