Oil Cooler: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the oil cooler and the fasteners.
- Connect the oil cooler tubes and install the retaining clips.
- Position the shield and install the retainers.
- Install the air duct and the retainers.
- Install the bracket and the fasteners.
Torque: Bracket-to-cooler bolts: 97 lb.in (11 Nm) Bracket-to-frame bolt: 22 lb.ft (30 Nm)
- Install the LH wheel and tire. Refer to: Wheel and Tire .
- Position the underbody shield and install the bolts.
- Position the underbody shield and install the bolts.
- Inspect and adjust the engine oil level.
Material: Motorcraft® SAE 5W-50 Full Synthetic Motor Oil / XO-5W50-QGT (WSS-M2C931-C)