Pinpoint Test E : The Manual Zoom Is Inoperative - Vehicles With Rear Only Parking Aid Camera

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

E1 PERFORM A NETWORK TEST
- Ignition ON.
- Using a diagnostic scan tool, perform a network test.
Do all modules pass the network test?

Yes GO to E2

No REFER to: Communications Network .

E2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST

Using a diagnostic scan tool, perform the BCM self-test.

Are any Diagnostic Trouble Codes (DTCs) present?

Yes	REFER to DTC Chart: BCM .

No	For vehicles with an 8 in (203 mm) touchscreen, GO to E3 For vehicles with a 4.2 in (107 mm) centerstack infotainment display, GO to E4

E3 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST

Using a diagnostic scan tool, perform the APIM self-test.

Are any Diagnostic Trouble Codes present?

Yes	For DTC C1001:01, GO to Pinpoint Test A For all other Diagnostic Trouble Codes (DTCs), REFER to: Information and Entertainment System - Vehicles With: Touchscreen Display . REFER to: Information and Entertainment System - Vehicles With: Sony Audio System .

GO to E5

E4 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) SELF-TEST

Using a diagnostic scan tool, perform the FCDIM self-test.

Are any Diagnostic Trouble Codes (DTCs) retrieved?

Yes	For DTC C1001:01, GO to Pinpoint Test A For all other Diagnostic Trouble Codes (DTCs), REFER to: Information and Entertainment System .

GO to E5

E5 CHECK FOR CORRECT REAR PARKING AID CAMERA OPERATION

Ignition OFF.

Disconnect and inspect the rear parking aid camera connector and related in-line connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the rear parking aid camera connector and related in-line connectors. Make sure they seat and latch correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera .

No	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.