Pinpoint Test B : Poor Image Quality - Rear Parking Aid Camera: Notes
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
Possible Causes
- Dirty or scratched camera lens
- Wiring, terminals or connectors
- Fuse
- Rear parking aid camera
- APIM (vehicles with 8 in (203 mm) touchscreen)
- Interference from other sources
Visual Inspection and Diagnostic Pre-Checks
- Make sure the rear video camera lens is clear of any debris.
- BJB Fuse 23 (15A).
- If the vehicle is equipped with an 8 in (203 mm) touchscreen display, perform an APIM reset and reevaluate the concern prior to following this pinpoint test. REFER to: Bezel Diagnostics - Vehicles With: Touchscreen Display . REFER to: Bezel Diagnostics - Vehicles With: Sony Audio System .
NOTE:
Before disconnecting the camera, verify the connector is properly seated and latched.