Pinpoint Test BB : The Ignition-Engine On Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

BB1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?

Yes GO to BB2

No Refer to IPC Guided Routine Testing .

BB2 CHECK THE DOOR AJAR INDICATION
- Open the driver door.
- Observe the door ajar warning indicator or door ajar RTT warning indicator.
Does the door ajar warning indicator or door ajar RTT warning indicator turn on with the driver door ajar?

Yes GO to BB3

No GO to Pinpoint Test AL

BB3 CHECK THE PRNDL OPERATION
- Shift the transmission range selector through the ranges while observing the PRNDL indication.
Does the PRNDL indication match the selected transmission range?

Yes GO to BB4

No GO to Pinpoint Test U

BB4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to DTC Chart: Instrument Panel Cluster (IPC) .

No DIAGNOSE all GWM Diagnostic Trouble Codes (DTCs) REFER to: Communications Network .