Network Message Chart
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Adaptive cruise control warning request | CCM | Input used to control the adaptive cruise control warning chime. |
| Cruise control status | PCM | Input used to control the adaptive cruise control warning chime. |
| Cross traffic alert left status | SODL | Input used to control the Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) chime. |
| Cross traffic alert right status | SODR | Input used to control the Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) chime. |
| Driver door ajar status | BCM | Input used for the ignition-engine on warning chime and the PRNDL not in park warning chime. |
| Driver safety belt buckle status | RCM | Input used to control the Belt-Minder® and safety belt warning chime. |
| Forward collision chime request | CCM | Input used for the forward collision warning chime. |
| Forward collision warning message request | CCM | Input used for the forward collision warning chime. |
| Front passenger detect status | RCM | Input used to control the Belt-Minder® chime. |
| Gear lever position | PCM | Input used to control the Belt-Minder® chime. |
| Headlamp on warning chime | BCM | Input used to control the headlamps on warning chime |
| Ignition status | BCM | Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting. Also used to control the PRNDL not in park warning chime. |
| Key-in-ignition status | BCM | Input used to control the key-in-ignition chime status. |
| Lane keeping system hands off display | IPMA | Input used to control the lane keeping system hands off the steering wheel warning chime. |
| Memory feedback request | DSM | Input used to control the memory feedback chime status. |
| Parking aid rear status | PAM | Input used to control the parking aid chime status. |
| Parking brake chime request | ABS module | Input used to control the electric parking brake chime status. |
| Passenger safety belt buckle status | RCM | Input used to control the Belt-Minder® chime. |
| Perimeter alarm chime request | BCM | Input used to control the perimeter alarm chime status. |
| Power liftgate chime request | RGTM | Input used to control the power liftgate warning chime. |
| Side obstacle sensor status-left | SODL | Input used to control the Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) chime. |
| Side obstacle sensor status-right | SODR | Input used to control the Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) chime. |
| Stability-traction control chime request | ABS module | Input used for the service AdvanceTrac® chime. |
| Transmission shift mode display | PCM | Input used for the ignition-engine on warning chime and the PRNDL not in park warning chime. |
| Transport mode | BCM | Input used to control the PRNDL not in park warning chime. |
| Turn indication request | BCM | Input used for the turn signal-hazard (tick-tock) chime. |
| Turn signal switch status | SCCM | Input used for the turn signal left on chime. |
| Vehicle speed | PCM | Input used to control the Belt-Minder® chime, ignition-engine on warning chime, and the PRNDL not in park warning chime. |
Module Network Input Messages - ACM and DSP
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Belt-Minder® audio mute | IPC | Input from the IPC used to control the Belt-Minder® audio chime output. |
| Chime source | IPC | Input used to configure the chime source (IPC or the audio system). |
| IPC chime request | IPC | Input from the IPC used to control the audio chime output. |
| Power up chime modules | IPC | Input used to initiate the audio system as the chime source, control the chime characteristics and chime location. |