Fuel Tank Filler Pipe: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation steps.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .
-
NOTE: The supplemental refueling adapter is located in the luggage compartment.
Install the supplemental refueling adapter and a length of semi-rigid fuel drain tube into the Easy Fuel™ (capless) fuel tank filler pipe.
- Attach the Fuel Storage Tanker to the fuel drain tube and drain as much fuel as possible from the Easy Fuel™ (capless) fuel tank filler pipe, lowering the fuel level below the fuel tank inlet spout. Use Special Service Tool: 292-00004 Fuel Tanker 100 GPM.
- Remove the LHR wheel and tire. Refer to: Wheel and Tire .
- Remove the retainers and the LHR wheel liner.
- Remove the retainers and the LH shield.
-
NOTE: Some residual fuel may remain in the fuel tank filler pipe. Carefully drain into a suitable container.
Release the clamp and position the fuel filler pipe hose aside.
Torque: 35 lb.in (4 Nm)
-
- Disconnect the vent tube quick release coupling. Refer to: Quick Release Coupling .
- Release the drain tube from the drain tube retainer.
- Remove the bolt and the fuel tank filler pipe.
Torque: 80 lb.in (9 Nm)