Catalytic Converter RH: Removal

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the catalytic converter is not being replaced, the catalyst monitor sensor does not need to be removed from the catalytic converter. Disconnecting the electrical connector is still necessary.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: Clean all exhaust connections before reassembly.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Disconnect the catalyst monitor sensor electrical connector and detach the wiring clip.

Courtesy of FORD MOTOR COMPANY
Remove the HO2S. Refer to: Heated Oxygen Sensor (HO2S) .
Remove the exhaust Y-pipe. Refer to: Exhaust Y-Pipe .
Remove the retainers and the RH underbody shield.

Courtesy of FORD MOTOR COMPANY
Remove the bolts and the RH catalytic converter heat shield.
Torque: 97 lb.in (11 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the bolts and the steering gear heat shield.
Torque: 71 lb.in (8 Nm)

Courtesy of FORD MOTOR COMPANY
Remove and discard the nuts. Remove the RH catalytic converter.

Courtesy of FORD MOTOR COMPANY
Remove and discard the gasket.

Courtesy of FORD MOTOR COMPANY
Remove and discard the studs.
Torque: 106 lb.in (12 Nm)

Courtesy of FORD MOTOR COMPANY