LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Automatic Transmission - 6-Speed Automatic Transmission - 6F35 (2 Of 2)) >> Removal And Installation >> Torque Converter Seal >> Installation

Torque Converter Seal: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new torque converter hub seal on the special tool. Use Special Service Tool: 307-627 Installer, Converter Seal.
    GFD280702Courtesy of FORD MOTOR COMPANY
  2. Using the special tool, install a new torque converter hub seal. Use Special Service Tool: 307-627 Installer, Converter Seal.
    GFD280703Courtesy of FORD MOTOR COMPANY
  3. Install the torque converter hub seal snap ring.
    GFD280700Courtesy of FORD MOTOR COMPANY
  4. NOTE: The torque converter is heavy. Be careful not to drop it or damage will result.

    Using the special tools, install the torque converter. Use Special Service Tool: 307-091 Handle, Torque Converter.

    GFD280704Courtesy of FORD MOTOR COMPANY
  5. Install the special tool. Install Special Service Tool: 307-566 Retainer, Torque Converter.
    GFD280705Courtesy of FORD MOTOR COMPANY
  6. Remove the transmission from the bench-mounted holding fixture. Use Special Service Tool: 307-003 (T57L-500-B) Holding Fixture, Transmission., 307-625 Fixture, Bench Mounting.
    GFD280697Courtesy of FORD MOTOR COMPANY
  7. Remove the special tool. Use Special Service Tool: 307-625 Fixture, Bench Mounting.
    GFD280696Courtesy of FORD MOTOR COMPANY
  8. Install the transmission. Refer to: Transmission 
scientia non olet · About LEMON Manuals