LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Automatic Transmission - 6-Speed Automatic Transmission - 6F35 (2 Of 2)) >> Removal And Installation >> Selector Shaft Seal >> Removal

Selector Shaft Seal: Removal

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the TR sensor. Refer to: Transmission Range (TR) Sensor .
  2. Remove and discard the selector shaft seal. Use the General Equipment: Flat Headed Screw Driver
GFD280657Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals