Variable Camshaft Timing (VCT) Oil Control Solenoid: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
RH (right-hand) Variable Camshaft Timing (VCT) Oil Control Solenoids
-
- Remove the nut.
Torque: 42 lb.in (4.8 Nm)
- Remove the bolt and remove the engine appearance cover.
Torque: 93 lb.in (10.5 Nm)
- Remove the nut.
- Disconnect the electrical connectors, remove the bolts and the RH VCT oil control solenoids.
Torque: 97 lb.in (11 Nm)
LH (left-hand) Variable Camshaft Timing (VCT) Oil Control Solenoids
-
- Remove the nut.
Torque: 42 lb.in (4.8 Nm)
- Remove the bolt and remove the engine appearance cover.
Torque: 93 lb.in (10.5 Nm)
- Remove the nut.
- Disconnect the electrical connectors, remove the bolts and the LH VCT oil control solenoids.
Torque: 97 lb.in (11 Nm)