Engine Oil Pressure (EOP) Sensor: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Remove retainers and the underbody shield.
- Disconnect the oil pressure sensor electrical connector.
- Remove the oil pressure sensor.
Torque: Stage 1: 133 lb.in (15 Nm) Stage 2: 180°