LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (ELECTRONIC ENGINE CONTROLS - 2.0L ECOBOOST (184kW/250PS) - MI4) >> Removal And Installation >> Engine Oil Pressure (EOP) Sensor >> Installation

Engine Oil Pressure (EOP) Sensor: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If the oil pressure sensor is to be reused, apply thread sealant.

    To install, reverse the removal procedure.

    Material: Motorcraft® Thread Sealant with PTFE / TA-24-B (WSK-M2G350-A2)

scientia non olet · About LEMON Manuals