Ignition Coil-On-Plug: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Both sides

Inspect the ignition coil-on-plugs. Replace any damaged ignition coil-on-plugs. Replace any of the ignition coil-on-plug seals or rubber boots with cracks, rips or tears.

Courtesy of FORD MOTOR COMPANY

Right side
- Install the ignition coil-on-plugs.
- Install and tighten the ignition coil-on-plug bolts in the following 2 stages.
  Torque: Stage 1: 62 lb.in (7 Nm) Stage 2: 48 deg.
Courtesy of FORD MOTOR COMPANY
Connect the ignition coil-on-plug electrical connectors.

Courtesy of FORD MOTOR COMPANY
Install the upper intake manifold. Refer to: Upper Intake Manifold .
Left side
- Install the ignition coil-on-plugs.
- Install and tighten the ignition coil-on-plug bolts in the following 2 stages.
  Torque: Stage 1: 62 lb.in (7 Nm) Stage 2: 48 deg.
Courtesy of FORD MOTOR COMPANY
Connect the ignition coil-on-plug electrical connectors. Attach the electrical harness retainer to the valve cover.

Courtesy of FORD MOTOR COMPANY
Connect the PCV hose quick release coupling. Refer to: Quick Release Coupling .

Courtesy of FORD MOTOR COMPANY
Remove the oil fill cap, install the engine appearance cover and then install the engine appearance cover retainers. Install the oil fill cap.

Courtesy of FORD MOTOR COMPANY